Quick Summary
The LIGHTEU DC 12V 500GPH non-automatic bilge pump is a submersible water pump for marine, yacht, caravan and outdoor use. It is described as a 12 volt pump with a stated output of 500 GPH and a hose connection of 19 mm.
The pump is described for sweet, salt and dirty water and as fully submersible. It also has a removable base, quick release SNAP-LOCK strainer and ignition protection.
Key Details
| Detail | Verified information and buyer relevance |
|---|---|
| Brand | LIGHTEU. Useful for matching the exact product variant. |
| Product type | Non-automatic bilge pump / submersible water pump. Check this suits the intended installation. |
| Power | DC 12V. The pump needs a matching 12 volt supply. |
| Stated output | 500 GPH. Compare this with the flow rate you need. |
| Flow rate | About 31.5 litres per minute. Useful when comparing with other pump options. |
| Pressure | 0.40 bar. Check this against the pumping task and hose setup. |
| Current | 1.6 Amp. Make sure the electrical setup matches the pump requirement. |
| Hose connection | 19 mm. Confirm the hose size before buying. |
| Material | Impact-resistant ABS. Check this against your preferred construction. |
| Drive shaft | Stainless steel drive shaft. A useful detail for parts matching. |
| Features | Removable base, quick release SNAP-LOCK strainer, ignition protected, fully submersible. |
| Use | Described for sweet, salt and dirty water. Check suitability for your intended water type. |
What to Compare Before Buying
- Power supply: This is a DC 12V pump, so the connected system must match that voltage.
- Flow requirement: The stated output is 500 GPH, so compare that figure with the pumping rate you need.
- Hose size: The 19 mm hose connection needs compatible hose and fittings.
- Installation space: As a submersible pump with a removable base, check the available space and mounting arrangement.
- Water type: It is described for sweet, salt and dirty water, so confirm that matches the intended job.
What Else You May Need
A compatible 12 volt electrical setup and a 19 mm hose or fitting arrangement are the main checks before fitting this pump.
Before You Decide
Confirm the 12V supply, the 19 mm hose connection and the 500 GPH flow figure before choosing an offer. Check that the non-automatic, fully submersible design matches the way you plan to use the pump.
Quick Way to Plan the Installation
Before fitting, map out the hose route, the power connection and the space where the pump will sit. That makes it easier to confirm the hose size, supply voltage and submersible layout are all aligned before installation.
Non-Automatic Operation
Non-automatic means you should not assume the pump will detect rising water and start by itself. Check how the intended installation will switch the pump on and off, and follow the product’s installation instructions for its electrical connections.









